Silicone Dehydrator Sheets for Jerky Producers
Jerky strips stick, tear and leave residue on bare trays. Our perforated silicone liners give strips a non-stick surface with air moving through the holes from both sides, so batches dry evenly and lift off cleanly.
Cut to your tray size, in 0.7 mm food-grade silicone, with orders starting at 20 pieces and free samples.
A mesh that holds strips and lets air through
1x1 mm is the all-round standard for jerky strips: open enough for airflow, tight enough to hold the strip flat.
4x4 mm large holes move the most air for thick or marinated strips where moisture removal is the bottleneck — use it only when strips are wider than the holes.
0.5 mm extra-fine is the choice when strips are cut thin or small pieces are in the batch.
Cut to your trays, not to a standard size list
We cut to your tray's inside dimensions — Excalibur 5-tray and 9-tray units take a 14-inch x 14-inch cut, COSORI CP267-FD takes about 13-inch x 12-inch, and round Nesco models take a 12.5-inch disc with a 3-inch center hole.
If your line mixes tray sizes, tell us the full set: one order can cover several cuts.
How to measure is in Dehydrator Sheet Sizes Explained: A Fit Guide for Excalibur, COSORI, Ninja & Nesco.
Ordering summary
Material
100% food-grade silicone, BPA-free, 0.7 mm
Temperature
-40°F to 356°F (-40°C to 180°C)
Compliance
FDA 21 CFR 177.2600 — test report on request
Standard sizes
60 x 80 / 70 x 90 / 80 x 90 cm; any dimension cut to order
Hole patterns
1x1 mm standard, 0.5 mm extra-fine, 4x4 mm large
MOQ
20 pcs
Lead time
1,000 pcs in 3-5 days
Samples
Free
Buyer questions
Frequently Asked Questions
Send your tray sizes and batch quantities through the contact page — we will confirm the cut and pattern, send a free sample, and quote from 20 pieces up.